Pumping Unit

Under Carriage Spray
As the car enters the bay, high powered jets of water are directed to the underbody of the vehicle-removing mud, dirt and salt that endangers the life of the chassis.

High Pressure Rinse
During the rinse pass the nozzles systematically rinse foam, dirt, dust, and devastating salt from the body of the vehicle.

Vortex Dryers
Our new Vortex Dryer System features 3 Blowers: all non-oscillating. Available in 30, 40 and 45 horse power configurations. (Optional)

HIGH PRESSURE UNIT
Motor
25 HP Electric Induction Motor,
30 Y Power System,
200/208/230/460V, 68.5 AMP, 1750 RPM

Pump
CAT 3535, Operating at 1200 psi
PRESOAK UNIT
Motor
3450 RPM, 2HP, 10, 230V,
1.4 AMP centrifugal type (3 each)
Oscillators
1/10 HP, 30, 220V
Motor
115 RPM (7 each)
BRIDGE
Motor
1 HP, 3 Phase, 1800 RPM, 208/230V,
3.4 AMP (2 each)
UTILITY REQUIREMENTS
Water
35 GPM water supply size 1 " ID pipe,
38 gallons per vehicle
Electric
150 AMP service to Power Pak 30-4 wire
SPACE REQUIREMENTS

Bay Space Without Dryer
Min. 15' wide x 32' long x 12' high

Bay Space With Dryer
Min. 16' wide x 32' long x 12' high

Equipment Room Size
Min. 6' wide x 12' long

Vehicle Clearance
Standard Max height 7'-10"
max width 7'-11" wheel base

Door Opening
10' Minimum • 12' Ideal

Pumping Unit	Bay Accessories
Watlow tank heaters for prespray and soap Gould 2HP low-pressure supply pumps Automatic chemical mixers for wax, prespray and soap 3535 CAT pump rated 35 GPM @ 1000 PSI Idec programmable processor Idec operator interface touch screen Onboard wash programming Self-diagnostic trouble shooting Onboard accounting Thermal overload kickout indicator light E.T.L. Approved	All aluminum frame with stainless side panels and light cabinets 30' aluminum travel track with removable stainless steel pipe Travel track re-circulating heat system Underneath spray with rocker panel blusters and mercury activated switch Mercury activated in place switch Galvanized steel or yellow powder coated guide rails On board backlit sign package

Under Carriage Spray As the car enters the bay, high powered jets of water are directed to the underbody of the vehicle-removing mud, dirt and salt that endangers the life of the chassis.

Chemicals The Vortex uses Magic Wand's patented two step chemical process. The first step is to apply a low ph prespray that loosens dirt and road film. The next step is to apply a high Ph soap that penetrates and suspends the dirt so it can easily be rinsed away.

Trifoam A foam blanket completely envelops the vehicle's exterior-for a total cleaning job. The Trifoam process can be done as a foam conditioner or a foam wax. (Optional)

High Pressure Rinse During the rinse pass the nozzles systematically rinse foam, dirt, dust, and devastating salt from the body of the vehicle.

Sign Package Our new Vortex sign package helps to market optional upgrades for increased revenue and is a standard part of the system.

Vortex Dryers Our new Vortex Dryer System features 3 Blowers: all non-oscillating. Available in 30, 40 and 45 horse power configurations. (Optional)
Bay Layout

Specifications
HIGH PRESSURE UNIT Motor 25 HP Electric Induction Motor, 30 Y Power System, 200/208/230/460V, 68.5 AMP, 1750 RPM Pump CAT 3535, Operating at 1200 psi PRESOAK UNIT Motor 3450 RPM, 2HP, 10, 230V, 1.4 AMP centrifugal type (3 each) Oscillators 1/10 HP, 30, 220V Motor 115 RPM (7 each) BRIDGE Motor 1 HP, 3 Phase, 1800 RPM, 208/230V, 3.4 AMP (2 each) UTILITY REQUIREMENTS Water 35 GPM water supply size 1 " ID pipe, 38 gallons per vehicle Electric 150 AMP service to Power Pak 30-4 wire SPACE REQUIREMENTS Bay Space Without Dryer Min. 15' wide x 32' long x 12' high Bay Space With Dryer Min. 16' wide x 32' long x 12' high Equipment Room Size Min. 6' wide x 12' long Vehicle Clearance Standard Max height 7'-10" max width 7'-11" wheel base Door Opening 10' Minimum • 12' Ideal